64 53 551 Removing and installing or replacing condenser for A/C system
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of injury!
Refrigerant circuit is under high pressure!
Follow safety information for handling R134a refrigerant. See SAFETY INFORMATION and INSTRUCTIONS FOR HANDLING .
Follow safety instructions for HANDLING REFRIGERANT OIL .
Avoid contact with refrigerant and refrigerant oil.
Refrigerant circuit is under high pressure!
Follow safety information for handling R134a refrigerant. See SAFETY INFORMATION and INSTRUCTIONS FOR HANDLING .
Follow safety instructions for HANDLING REFRIGERANT OIL .
Avoid contact with refrigerant and refrigerant oil.
IMPORTANT:
Risk of damage!
Restart engine only when air conditioning system has been correctly filled.
Follow INSTRUCTIONS for opening and replacing parts in refrigerant circuit.
If air conditioning system is opened for more than 24 hours: REPLACING DRIER INSERT FOR A/C SYSTEM
Restart engine only when air conditioning system has been correctly filled.
Follow INSTRUCTIONS for opening and replacing parts in refrigerant circuit.
If air conditioning system is opened for more than 24 hours: REPLACING DRIER INSERT FOR A/C SYSTEM
Necessary preliminary tasks:
Release screws (1) on left and right from cover (3).
Release screws (2) behind sealing lip.
Lift out cover (3).
Feed out condenser below it by lifting upwards.
After installation: