13 54 015 Removing and installing/sealing left throttle body (N63 hybrid)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: High-voltage system - danger to life!

WARNING: The following points must be strictly observed prior to starting work:

DE-ENERGIZE THE HIGH-VOLTAGE SYSTEM
Observe SAFETY INSTRUCTIONS for handling with hybrid vehicles

Necessary preliminary tasks:

Turn off ignition
Remove left INTERCOOLER

Unlock plug (1) and remove.

Unfasten screws (2).

Tightening torque 13 54 1AZ .

Remove throttle valve assembly (3).

Installation note:

Check plug connection (1) for coolant remnants. If necessary, clean plug connection (1) with compressed air.

Fig 1: Identifying Plug Connection, Throttle Valve Assembly And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace sealing ring (1) of throttle assembly (2).

Fig 2: Identifying Sealing Ring And Throttle Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check stored fault message.

Delete fault memory.