LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1995 >> Villager LS >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Analog Instrument Panels >> System Tests >> Test E: Coolant Temperature Always Reads Cold

Test E: Coolant Temperature Always Reads Cold

NOTE: Water temperature indicator sensor is also known as the coolant temperature sensor. This is NOT the same sensor used by the PCM.
  1. Check water temperature indicator sender unit. See WATER TEMPERATURE INDICATOR SENDER UNIT  under COMPONENT TESTS. Is the water temperature indicator sender unit okay? If yes, go to next step. If no, replace the water temperature indicator sender unit.
  2. Check coolant temperature gauge. See COOLANT TEMPERATURE GAUGE  under COMPONENT TESTS. Is the coolant temperature gauge okay? If yes, go to next step. If no, replace coolant temperature gauge.
  3. Check wire between water temperature indicator sender unit and instrument cluster. Turn key OFF. Disconnect the instrument cluster connector C270 and the water temperature indicator sender unit connector. Measure the resistance of the Blue/White wire between the instrument cluster connector C270 and the water temperature indicator sender unit connector. See WIRING DIAGRAMS  . Is the resistance less than 5 ohms? If yes, replace instrument cluster printed circuit. See INSTRUMENT CLUSTER PRINTED CIRCUIT  under REMOVAL & INSTALLATION. If no, service Blue/White wire.
scientia non olet · About LEMON Manuals