Remove/Install Lamp Unit - Ar82.10-D-4730H
MODEL 906
Shown on left side of vehicle on model 906 without CODE XM0 (Model refinement)
| Remove/install | |||
| Risk of death due to high voltage in xenon headlamps. Risk of explosion/risk of fire caused by highly flammable materials in the vicinity of damaged xenon bulbs. Risk of injury caused by UV light, hot components at xenon headlamps and glass splinters produced by bursting xenon bulbs. Risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming into contact with skin | Do not touch parts conducting high voltage. Persons with active electronic implants (e.g. cardiac pacemakers) must never work on xenon headlamps. Switch off the entire lighting system. Wear insulated safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure sufficient ventilation in the working area. | AS82.10-Z-0001-01A | |
| 1 | Switch off the ignition and remove the transmitter key from the EIS control unit | Model 906 with CODE LG0 (Bi-xenon headlamp) or with CODE LG1 (Bi-xenon headlamp with cornering lights) | |
| 2.1 | Remove plate under front grille | MODEL 906 without CODE XM0 (Facelift) without CODE ZX8 (Dodge brand scope) without CODE ZX9 (Freightliner (FTL) brand scope) |
|
| Model 906 | AR88.00-D-2200SD | ||
| 2.2 | Remove headlamp trim | MODEL 906 with CODE ZX8 (Dodge brand scope) with CODE ZX9 (Freightliner (FTL) brand scope) without CODE XM0 (Facelift) Vehicles without CODE XM0 (Model refinement), with CODE ZX8 (Dodge brand scope), with CODE ZX9 (Freightliner (FTL) brand scope) |
|
| Model 906 | AR88.00-D-2100SF | ||
| 2.3 | Remove bumper | MODEL 906 with CODE XM0 (Facelift) |
|
| Model 906 | AR88.20-D-2000M | ||
| 3 | Remove bolt (1) | ||
| 4 | Unclip bracket (3) from fender | MODEL 906 without CODE XM0 (Facelift) |
|
| 5 | Remove left or right lamp unit until electrical connector (2) is accessible | ||
| 6 | Disconnect electrical connector (2) and remove left or right lamp unit | ||
| 7 | Install in the reverse order | ||
| Check | |||
| 8 | Perform function check of front exterior lights and headlamp range adjustment | ||
| AP82.10-D-8251H | |||
| 9 | Check headlamp adjustment and adjust if required | ||
| MODEL 906 without CODE LG0 (Bi-xenon headlamps) without CODE LG1 (Bi-xenon headlamp with corner-illuminating fog lamps) |
AP82.10-D-8260A | ||
| MODEL 906 with CODE LG1 (Bi-xenon headlamp with corner-illuminating fog lamps) |
AP82.10-D-8260B |