Perform a wheel alignment check - AR40.20-P-0200CW
MODEL 204
| Measuring, adjusting | |||
|---|---|---|---|
| 1 | Drive the vehicle onto the measuring station and secure using the parking brake | ||
| 2 | Carry out conditions and tests for chassis alignment | AR40.20-P-0260SX | |
| 3 | Using the adapter, install the brake pedal retaining tool between the pedal and the driver seat | ||
| *000589183100 | |||
| *211589003100 | |||
| 4.1 | Place the transmission in neutral | Vehicles with manual transmission | |
| 4.2 | Move selector lever to position "P" | Vehicles with automatic transmission | |
| 5 | Open window on driver door and close driver door | The vehicle must not be loaded again. |
|
| 6 | Switch off ignition | ||
| 7 | Attach Mercedes-Benz quick-clamping devices | AR40.20-P-0230SX | |
| 8 | Fit on measuring heads | ||
| 9 | Unlock turnplates and sliding platforms | ||
| 10 | Perform initial measurement | ||
| 11 | Check vehicle level at front and rear axle using electronic inclinometer and adjust if necessary | AR40.20-P-0301CW | |
| 12 | Checking rear axle camber | According to results of initial measurement. |
AR40.20-P-0331CW |
| 13 | Adjust rear-axle toe | According to results of initial measurement. | AR40.20-P-0261CW |
| 14 | Adjust camber and caster at the front axle | According to results of initial measurement. | AR40.20-P-0263CW |
| 15 | Adjust front axle toe | According to results of initial measurement. | AR40.20-P-0264CW |
| 16 | Check toe-out on turns | According to results of initial measurement. | AR40.20-P-0325CW |
| 17 | Perform final measurement | ||
| 18 | Detach sensors | ||
| 19 | Detach Mercedes-Benz quick-clamping devices | AR40.20-P-0230SX | |
| 20 | Remove brake pedal jack tool with its adapter | *000589183100 | |
| *211589003100 | |||
| 21 | Drive vehicle off measuring system | ||
| 22 | Lock turntables and sliding platforms |