Retrofitting trailer coupling - AN31.10-P-8080FFC

MODEL 210.206 /216 /226 /235 /245 /248 /261 /262 /263 /265 /270 /281 /282 /283 1A as of 962231 as of 1.6.99 

as of 6.99 with code 800, vehicles with integral turn signal indicators in the outside mirrors 

Shown on detachable ball neck 

Fig 1: Retrofitting Trailer Coupling Components Shown On Detachable Ball Neck

	Remove/install
	Notes regarding installation of trailer hitch	Model 210.	AH31.10-P-1000-02FF
1	Remove rear seat and rear seat backrest	Remove rear seat only.
			AR91.12-P-1700FA
2	Connect quiescent current retention unit		*WH58.30-Z-1012-09A
3	Disconnect ground cable of battery	To protect against unintended contact, insulate the disconnected ground line
			AR54.10-P-0003A
4	Remove rear fuse box
			AR54.15-P-1320A
5	Remove left/right front door sill molding and rear left/right door sill molding	Open the cable duct.
6	Remove the paneling on the left/right B-pillar	Remove only longitudinal member paneling.
			AR68.30-P-4700F
7	Remove cover below instrument panel (left)
			AR68.10-P-1500F
8	Remove paneling at the bottom of the A-pillar on the left and right	Open the cable duct.
9	Remove spare wheel
10	Remove right front floor covering
			AR68.20-P-2070F
11.1	Remove right front footrest	Only on vehicles with Parktronik system code 220.
12	Remove side paneling in left rear
			AR68.30-P-4780B
13	Remove storage compartment paneling in trunk
14	Remove rear bumper
			AR88.20-P-2200FB
15	Remove complete exhaust system	Only remove the rear muffler as from the threaded connection.
		ENGINE 112.921 in MODELS 210.263/281, ENGINE 112.941 in MODELS 210.265/282, Engine 113.940 in model 210.270.	AR49.10-P-7000A
		Engine 111.942 in model 210.235, Engine 111.947 in model 210.245.	AR49.10-P-7000BA
		Engine 611.961 in model 210.206, Engine 612.961 in model 210.216, Engine 613.961 in model 210.226.	AR49.10-P-7000HB
16	Remove shroud above rear muffler
	Install
17	Retrofit detachable mechanical body components		AN31.11-P-8080-05FF
		Bolt, crossmember to vehicle	*BA31.10-P-1001-01B
		Nut to counter tab	*BA31.10-P-1002-01B
18.1	Print document "Trailer hitch, confirmation"	Print out the document "Trailer hitch, certification" and submit on final inspection of the installation For do-it-yourself installers, the detailed installation instructions must be printed out and given to the customer. These must be submitted by the customer on final inspection. * For Germany only	OF31.10-P-1000-01I
19	Connect wiring harness		AN31.19-P-8080-03FFC
20	Reassemble vehicle
21	Perform function test of light signals at the trailer hitch socket.		AN31.19-P-8100-06F
22	Enter special equipment on vehicle data card and in vehicle data card online	Code 550 trailer hitch.

Trailer coupling