Retrofitting auto-pilot system (APS) - AN82.61-P-1000M

MODEL 210.2## 1# up to 30.6.99 except CODE (316) MB GSM cellular telephone (D2B) except CODE (317) GSM portable cellular telephone (D2B) 

System illustrated on model 210 T-model 

Fig 1: Identifying Auto-Pilot System (APS) Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Survey of APS generations		GF82.61-P-0001-04A
	Removal
1	Disconnect ground lead from battery
			AR54.10-P-0003A
2	Remove load compartment paneling on left
3	Remove rear headliner
4	Open front fuse and relay box
5	Lift floor covering on driver's side
			AR68.20-P-2050F
6	Remove left foot support
7	Remove cover below instrument panel on left
			AR68.10-P-1400F
8	Remove radio
9	Open control module box
10	Retrofitting auto-pilot system wiring harness	For installation of 3rd generation APS as of 06/96 or with engine 119 or engine 602
		For installation of 3rd generation APS up to 05/96 with engines 104, 111, 112, 604, 605 or engine 606	AN82.61-P-1001-01O
	Installation		AN82.61-P-1001-01Q
11	Retrofit antenna for global positioning system (GPS) on roof		AN82.61-P-7474-04R
12	Retrofit navigation processor (APS)		AN82.61-P-7410-05I
13	Retrofit radio and navigation operating unit (APS)	Vehicles with CD changer require a new CD changer wiring harness	AN82.61-P-7412-06E
14	Code APS	Only required when operated for first time	AN82.61-P-1000-01A
15	Reassemble vehicle; steps 9-1
16	Start up and check for proper function	Code APS to vehicle with HHT	*WH58.30-Z-1036-13A
17	Diagnose error messages with APS test program	Only if error messages are present
			AD82.61-P-5000B
18	Electrical wiring diagram for retrofitting APS		AN82.61-P-1000-02D