Removing and installing front floor covering (on left) - AR68.20-P-2050F
MODEL 210
| Removal, installation | |||
| 1 | Cover below instrument panel removed (left) | AR68.10-P-1500F | |
| 2 | Pull off cover (2) on longitudinal member upward (3 clips) | ||
| 3 | Pull edge guard (1) off in lower area of A-pillar | ||
| 4 | Remove cover (3) and unscrew screw (4) | ||
| 5 | Remove paneling (5) toward rear; for this purpose unclip clips (6, 2 each) on A-pillar | ||
| 6 | Unscrew nuts (8, 2 each) on accelerator pedal (9) and remove accelerator pedal from threaded stud | ||
| 7 | Move driver's seat all the way down | ||
| 8 | Lift floor covering (10) at rear, pull out along center console and then remove floor covering toward rear | ||
| 9 | Reinstall in opposite order |