Remove/install control cable for engine hood - AR88.40-P-3100GH
MODEL 163.113 /128 /136 /154 /157 /172 /174 /175
Illustrated up to VIN A145272, X708318
| Removing and installing | |||
|---|---|---|---|
| 1 | Open engine hood and raise to vertical position | Up to VIN A145272, X708318. | AR88.40-P-1000GH |
| As of VINA145273, X708319. | AR88.40-P-1000GI | ||
| 2.1 | Remove upper frame cross member | Only up to VIN A145272, X708318 | AR62.30-P-2300GH |
| 2.2 | Remove engine hood lock | Only as of VIN A145273, X708319. | AR88.40-P-3200GI |
| 3.1 | Unhook engine hood control cable from clip at bottom of radiator cross member | Only as of VIN A145273, X708319. | |
| 4 | Remove cover from fuse and relay box | ||
| 5 | Unhook clips (1) from body | ||
| 6 | Remove left cover below instrument panel | Left hand drive vehicle. | AR68.10-P-1500GH |
| Vehicles with right-hand steering up to VINA145272, X708318. | AR68.10-P-1520GH | ||
| Vehicles with right-hand steering as of VINA145273, X708319. | AR68.10-P-1520GI | ||
| 7 | Remove paneling in left footwell | AR68.30-P-4010GH | |
| 8 | Unhook engine hood control cable at side at clip in footwell | ||
| 9 | Remove rubber grommet (2) from fuse and relay box | ||
| 10 | Pull out engine hood control cable (3) through firewall on engine side and remove | ||
| 11 | Install in the reverse order |