LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Lubrication (VIN Y)) >> Engine Oil Solenoid Valve Removal/Installation (VIN Y) >> Notes

Engine Oil Solenoid Valve Removal/Installation (VIN Y): Notes

WARNING: This page is about a different variant/trim than selected.

Replacement Part 

Bolt
Quantity: 3
Location of use: Engine oil solenoid valve
Gasket
Quantity: 1
Location of use: Engine oil solenoid valve

Oil and Chemical Type 

Silicone sealant
Type: TB1207B or equivalent
Engine oil
Type: Recommended oil
WARNING:
  • Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled.
  • A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work around or under a lifted vehicle if it is not securely supported on safety stands.
  • Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the front under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION .)
  3. Remove the front wheel and tire. (RH) (See WHEEL AND TIRE REMOVAL/INSTALLATION .)
  4. Remove the front splash shield (RH). (See SPLASH SHIELD REMOVAL/INSTALLATION .)
  5. Remove the water pump drive belt with the generator drive belt still installed and set it aside. (See WATER PUMP DRIVE BELT REMOVAL/INSTALLATION (VIN Y) .)
  6. Remove the engine oil temperature sensor/engine oil pressure sensor. (See ENGINE OIL TEMPERATURE SENSOR/ENGINE OIL PRESSURE SENSOR REMOVAL/INSTALLATION (VIN Y) .)
  7. Remove in the order indicated in the table.
  8. Install in the reverse order of removal.
  9. Start the engine and confirm that there is no oil leakage.
    • If there is oil leakage, repair or replace the applicable part.
Fig 1: Engine Oil Solenoid Valve Components Location With Torque Specification (VIN Y)
G16371717Courtesy of MAZDA MOTORS CORP.
ENGINE OIL SOLENOID VALVE COMPONENT OPERATIONS

Component No Refer to
1 Bolt
(See BOLT REMOVAL NOTE .)
(See BOLT INSTALLATION NOTE .)
2 Engine oil solenoid valve connector
(See ENGINE OIL SOLENOID VALVE CONNECTOR DISCONNECTING NOTE .)
3 Engine oil solenoid valve component
4 Engine oil solenoid valve
5 Spacer