LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> MX-5 Miata RF Club >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> Front Console Removal/Installation

Front Console Removal/Installation

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Selector lever knob (AT) (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION .)
    2. Shift lever knob (MT)
    3. Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION .)
    4. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION .)
    5. Parking brake lever boot panel (See PARKING BRAKE LEVER BOOT PANEL REMOVAL/INSTALLATION .)
    6. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION .)
    7. Front console panel (See FRONT CONSOLE PANEL REMOVAL/INSTALLATION .)
  3. Move the front console component in the direction of the arrow shown in the illustration and detach the clip from the dashboard.
    G14603018Courtesy of MAZDA MOTORS CORP.
  4. Disconnect the auxiliary jack/USB port/SD card slot hub connector.
  5. Disconnect the indicator unit connector.
  6. Remove the front console component.
  7. When replacing the front console, remove the following parts:
    1. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
    2. Auxiliary jack/USB port/SD card slot hub (See AUXILIARY JACK/USB PORT/SD CARD SLOT HUB REMOVAL/INSTALLATION .)
    3. Indicator unit (See INDICATOR UNIT REMOVAL/INSTALLATION .)
  8. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals