LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> MX-5 Miata RF Club >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> Upper Panel Removal/Installation

Upper Panel Removal/Installation

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Selector lever knob (AT) (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION .)
    2. Shift lever knob (MT)
    3. Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION .)
  3. Move the upper panel in the order of arrows (1) and (2) shown in the illustration and detach clips A and B, and the hooks from the rear console.
    G14603108Courtesy of MAZDA MOTORS CORP.
  4. Remove the drive selection switch when replacing the upper panel. (AT) (See DRIVE SELECTION SWITCH REMOVAL/INSTALLATION [SKYACTIV-G 2.0] .)
  5. Remove the commander switch when replacing the upper panel. (See COMMANDER SWITCH REMOVAL/INSTALLATION .)
  6. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals