LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> MX-5 Miata RF Club >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> Rear Console Removal/Installation

Rear Console Removal/Installation

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Selector lever knob (AT) (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION .)
    2. Shift lever knob (MT)
    3. Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION .)
    4. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION .)
    5. Parking brake lever boot panel (See PARKING BRAKE LEVER BOOT PANEL REMOVAL/INSTALLATION .)
  3. Remove the screws.
    G14603048Courtesy of MAZDA MOTORS CORP.
  4. Remove the wiring harness clip.
    G14603049Courtesy of MAZDA MOTORS CORP.
  5. Hold the shaded areas shown in the illustration, lift up the rear console in the order of arrow (1) and (2), and detach the clips.
    G14603050Courtesy of MAZDA MOTORS CORP.
  6. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals