LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 606 (Air Bag System) >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Procedures >> Deployment Procedure for Inside of Vehicle >> Curtain Air Bag Module

Curtain Air Bag Module

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the following parts:
    1. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Rear side seat (See REAR SEAT BACK REMOVAL/INSTALLATION .)
    3. Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
  2. Partially peel back the seaming welt.
  3. Remove the C-pillar trim. (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
  4. Disconnect the curtain air bag module connector.
    5. Fig 1: Connecting SST To Curtain Air Bag Module
    G06200473Courtesy of MAZDA MOTORS CORP.
  5. Connect the SST (Deployment tool)  to the SST (Adapter harness)  .
    6. Fig 2: Connecting Deployment Tool To SST
    G06200471Courtesy of MAZDA MOTORS CORP.
  6. Connect the SST (Deployment tool)  to the battery. Connect the power supply red clip to the positive battery terminal, and the black clip to the negative battery terminal.
  7. Verify that the red lamp on the SST (Deployment tool)  is illuminated.
  8. Verify that all persons are standing at least 6 m {20 ft}  away from the vehicle.
  9. Press the activation switch on the SST (Deployment tool)  to operate (deploy) the curtain air bag module.
    Fig 3: Identifying Activation Switch On SST
    G06200465Courtesy of MAZDA MOTORS CORP.
    WARNING:
    • The air bag module is very hot Immediately after it is operated (deployed). You can be burned. Do not touch the air bag module for at least 15 min after deployment.
  10. Disconnect the SST (Deployment tool)  from the SST (Adapter harness)  .
scientia non olet · About LEMON Manuals