LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2000 >> LS 3.9 A >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panels - Analog >> Self-Diagnostic System

Self-Diagnostic System

NOTE: Before beginning self-diagnostics, perform TROUBLE SHOOTING  .
NOTE: Test procedures are written specifically for New Generation Star (NGS) tester. Generic scan tools may not have the capability of performing all the same functions. Refer to scan tool manufacturer's instructions.
NOTE: Anti-Lock Brake System (ABS) control module is referred to as a Stability Assist Module (SAM) if vehicle is equipped with traction control and stability assist. Next Generation Speed Control (NGSC) servo is an integral part of the Powertrain Control Module (PCM). Message center module is an integral part of the instrument cluster. Steering Column Lock Module (SCLM) may also be referred to as a Steering Column Lock Unit (SCLU) or steering column lock.
NOTE: Remote Emergency Satellite Cellular Unit (RESCU) module, Driver's Seat Module (DSM) and Steering Column Lock Module (SCLM) will fail data link diagnostic test if vehicle is not equipped with that module(s). Vehicles with voice activated cellular phone are equipped with a RESCU module. Vehicles with memory seats are equipped with a DSM. Vehicles with a manual transmission are equipped with a SCLM.

Connect New Generation Star (NGS) Tester to Data Link Connector (DLC), located below instrument panel. Using NGS tester, perform data link diagnostic test. See DATA LINK DIAGNOSTIC TEST under SELF-DIAGNOSTIC SYSTEM in MODULE COMMUNICATIONS NETWORK - LS article. If NGS tester displays CKT914, CKT915 or CKT70=ALL ECUS NO RESP/NOT EQUIP, repair module communications concern. See MODULE COMMUNICATIONS NETWORK - LS article.

If NGS tester displays NO RESP/NOT EQUIP for instrument cluster, perform TEST A: NO COMMUNICATION WITH INSTRUMENT CLUSTER  under SYSTEM TESTS. If NGS tester displays NO RESP/NOT EQUIP for message center, perform TEST A: NO COMMUNICATION WITH INSTRUMENT CLUSTER  under SYSTEM TESTS. If NGS tester displays NO RESP/NOT EQUIP for Front Electronic Module (FEM), perform TEST B: NO COMMUNICATION WITH FRONT ELECTRONIC MODULE  under SYSTEM TESTS. If NGS tester displays NO RESP/NOT EQUIP for Rear Electronic Module (REM), perform TEST C: NO COMMUNICATION WITH REAR ELECTRONIC MODULE  under SYSTEM TESTS. If NGS tester displays NO RESP/NOT EQUIP for Remote Emergency Satellite Cellular Unit (RESCU), perform TEST AA: NO COMMUNICATION WITH REMOTE EMERGENCY SATELLITE CELLULAR UNIT  under SYSTEM TESTS. If NGS tester displays NO RESP/NOT EQUIP for Restraints Control Module (RCM), repair restraint system concern. For information on air bag DIAGNOSIS & TESTING or DISPOSAL PROCEDURES, see lemon-25(R) AIR BAG SERVICE & REPAIR MANUAL, DOMESTIC & IMPORTED MODELS.

If NGS tester displays SYSTEM PASSED, retrieve and record DTCs from all modules. Erase DTCs from all modules. Perform instrument cluster, message center, FEM, RESCU and REM self-test. Perform appropriate test under SYSTEM TESTS in accordance with DTC retrieved. See FRONT ELECTRONIC MODULE DTC INDEX  , INSTRUMENT CLUSTER DTC INDEX  , MESSAGE CENTER MODULE DTC INDEX  , REAR ELECTRONIC MODULE DTC INDEX  and/or REMOTE EMERGENCY SATELLITE CELLULAR UNIT DTC INDEX  table. Codes listed in these tables are only for testing covered in this article. For complete DTC listing, see DIAGNOSTIC TROUBLE CODE (DTC) DEFINITIONS in MODULE COMMUNICATIONS NETWORK - LS article. If self-test is passed and no DTCs are retrieved, repair by symptom. See SYMPTOM INDEX  under SYSTEM TESTS.

FRONT ELECTRONIC MODULE DTC INDEX

DTC (1) Description Perform Test
B1342 ECU Defective (2)
B1479 Wiper Washer Fluid Level Sensor Circuit Failure M 
B2442 Intrusion Sensor Fault (3)
B2443 Powertrain Performance Mode Switch Circuit Failure (4)
B2477 Module Configuration Failure (5)
C1284 Oil Pressure Switch Failure F 
C1446 Brake Switch Circuit Failure K 
(1) Codes listed in this table are only for testing covered in this article. For complete DTC listing, see DIAGNOSTIC TROUBLE CODE (DTC) DEFINITIONS in MODULE COMMUNICATIONS NETWORK - LS article.
(2) Using NGS tester, retrieve and document all continuous DTCs. Perform Front Electronic Module (FEM) self-test. If DTC B1342 is retrieved again, replace FEM.
(3) Information is not available from manufacturer.
(4) Not used on this vehicle.
(5) Configure Front Electronic Module (FEM). See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION. If module was configured correctly, replace FEM and repeat self-test.
INSTRUMENT CLUSTER DTC INDEX

DTC (1) Description Perform Test
B1201 Fuel Sender Circuit Failure D 
B1205 Instrument Cluster Switch 1 Assembly Circuit Failure (2)
B1209 Instrument Cluster Switch 2 Assembly Circuit Failure (2)
B1246 Dim Panel Potentiometer Switch Circuit Failure AU 
B1342 ECU Defective (3)
B1352 Ignition Key-In Circuit Failure AL 
B1676 Battery Voltage Out Of Range J 
B2143 NVM Memory Failure Z 
B2477 Module Configuration Failure (4)
U1131 SCP Invalid/Missing Data For Fuel System D 
(1) Codes listed in this table are only for testing covered in this article. For complete DTC listing, see DIAGNOSTIC TROUBLE CODE (DTC) DEFINITIONS in MODULE COMMUNICATIONS NETWORK - LS article.
(2) Replace instrument cluster.
(3) Using NGS tester, retrieve and record all continuous DTCs. Perform instrument cluster self-test. If DTC B1342 still exists, replace instrument cluster.
(4) Configure instrument cluster. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION. If module was configured correctly, replace instrument cluster and repeat self-test.
MESSAGE CENTER MODULE DTC INDEX (1)

DTC (2) Description Perform Test
B1205 Message Center Switch Assembly Circuit Failure AB 
B1342 ECU Defective (3)
B1676 Battery Voltage Out Of Range A 
B2477 Module Configuration Failure (4)
(1) The message center module is an integral part of the instrument cluster.
(2) Codes listed in this table are only for testing covered in this article. For complete DTC listing, see DIAGNOSTIC TROUBLE CODE (DTC) DEFINITIONS in MODULE COMMUNICATIONS NETWORK - LS article.
(3) Using NGS tester, retrieve and document all continuous DTCs. Perform instrument cluster self-test. If DTC B1342 is retrieved again, replace instrument cluster.
(4) Configure instrument cluster. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION. If module was configured correctly, replace instrument cluster and repeat self-test.
REAR ELECTRONIC MODULE DTC INDEX

DTC (1) Description Perform Test
B1201 Fuel Sender Circuit Failure D 
B1342 ECU Defective (2)
B2477 Module Configuration Failure (3)
(1) Codes listed in this table are only for testing covered in this article. For complete DTC listing, see DIAGNOSTIC TROUBLE CODE (DTC) DEFINITIONS in MODULE COMMUNICATIONS NETWORK - LS article.
(2) Using NGS tester, retrieve and document all continuous DTCs. Perform Rear Electronic Module (REM) self-test. If DTC B1342 is retrieved again, replace REM.
(3) Configure Rear Electronic Module (REM). See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION. If module was configured correctly, replace REM and repeat self-test.
REMOTE EMERGENCY SATELLITE CELLULAR UNIT DTC INDEX

DTC (1) Description Perform Test
B1342 ECU Defective (2)
B2141 NVM Configuration Failure (3)
B2477 Module Configuration Failure (4)
(1) Codes listed in this table are only for testing covered in this article. For complete DTC listing, see DIAGNOSTIC TROUBLE CODE (DTC) DEFINITIONS in MODULE COMMUNICATIONS NETWORK - LS article.
(2) Using NGS tester, retrieve and document all continuous DTCs. Perform Remote Emergency Satellite Cellular Unit (RESCU) self-test. If DTC B1342 is retrieved again, replace RESCU.
(3) Using NGS tester, retrieve and document all continuous DTCs. Perform Remote Emergency Satellite Cellular Unit (RESCU) self-test. If DTC B2141 is retrieved again, replace RESCU.
(4) Configure Remote Emergency Satellite Cellular Unit (RESCU). See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION. If module was configured correctly, replace RESCU and repeat self-test.