LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> LX 570 >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery / Charging System (Service Information) >> Generator >> Removal [09/2015 - ] >> Procedure

Removal [09/2015 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - 08/2019] Refer to INITIALIZATION [08/2019 - ] ).

  3. REMOVE UPPER RADIATOR SUPPORT SEAL 

    Refer to PROCEDURE - Step 3

  4. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 5

  5. REMOVE FRONT FENDER APRON TRIM PACKING A 

    Refer to PROCEDURE - Step 6

  6. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 1

  7. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH 

    Refer to PROCEDURE - Step 2

  8. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4

  9. REMOVE FAN AND GENERATOR V BELT 

    Refer to PROCEDURE - Step 6

  10. REMOVE AIR CLEANER HOSE ASSEMBLY 

    Refer to PROCEDURE - Step 10

  11. REMOVE AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 25

  12. DISCONNECT VANE PUMP ASSEMBLY 

    Refer to PROCEDURE - Step 31

  13. DISCONNECT OIL COOLER TUBE 

    Refer to PROCEDURE - Step 55

  14. REMOVE GENERATOR ASSEMBLY 
    1. Disconnect the generator connector.
      GTY596006Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the terminal cap.
    3. Remove the nut and disconnect the generator wire from terminal B.
    4. Detach the clamp and disconnect the generator wire.
    5. Remove the bolt and wire harness clamp bracket from generator assembly.
    6. Remove the 3 bolts, nut and generator assembly.
      GTY546176Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Remove the stud bolt from the cylinder block.
scientia non olet · About LEMON Manuals