LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Parking Brake) >> Parking Brake Pedal >> Installation

Parking Brake Pedal: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY 
    1. Install the parking brake control pedal assembly to the body, and temporarily tighten the 3 nuts
    2. Fully tighten the 3 nuts in the order shown in the illustration

      Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf) 

    3. Connect the parking brake switch connector
      Fig 1: Identifying Nuts Tightening Sequence
      G05752864Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Connect the instrument panel junction block assembly with the 2 nuts.
    5. Install the No. 1 parking brake cable assembly to the body with the 3 nuts and 2 bolts

      Torque: Nut 

      6.0 N*m (61 kgf*cm, 53 in.*lbf) 

      Bolt 

      8.0 N*m (82 kgf*cm, 71 in.*lbf) 

      Fig 2: Locating Instrument Panel Junction Block Assembly Nuts
      G05297352Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Fig 3: Locating No. 1 Parking Brake Cable Assembly Bolts And Nuts
      G05752861Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL PARKING BRAKE EQUALIZER 
    1. Install the parking brake equalizer to the No. 1 parking brake cable assembly in the order shown in the illustration.
      Fig 4: Installing Parking Brake Equalizer To No. 1 Parking Brake Cable Assembly
      G05752867Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Slide the rubber boot back as shown in the illustration.
      Fig 5: Sliding Rubber Boot Back
      G05752868Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the No. 2 parking brake cable assembly and No. 3 parking brake cable assembly to the parking brake equalizer.
    4. Install the No. 2 parking brake cable assembly and No. 3 parking brake cable assembly to the body with the 2 bolts.

      Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

      Fig 6: Locating Parking Brake Equalizer Bolts
      G05752858Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL PARKING BRAKE RETURN WITH DAMPER SPRING 
    1. Install the parking brake return with damper spring.
    Fig 7: Identifying Parking Brake Return With Damper Spring
    G05752857Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY 

    HINT.

    Refer to the instructions for Installation of the propeller shaft with center bearing assembly (See INSTALLATION ).

  5. INSTALL FRONT UPPER FLOOR REAR SUB PANEL 
    1. Install the front upper floor rear sub panel to the body with the 4 bolts.

      Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf) 

    2. Engage the 8 clamps.
    Fig 8: Locating Front Upper Floor Rear Sub Panel Bolts
    G05752855Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL CENTER AIRBAG SENSOR ASSEMBLY  (See INSTALLATION )
  7. INSTALL NO. 2 REAR AIR DUCT 
  8. INSTALL REAR AIR DUCT GUIDE LH 
  9. INSTALL FRONT FLOOR SILENCER PAD LH 
  10. INSTALL NO. 3 DASH PANEL INSULATOR PAD 
    1. Install the No. 3 dash panel insulator pad with the clip.
  11. INSTALL FRONT FLOOR FOOTREST LH 
    1. Engage the 2 clips and install the front floor footrest LH.
  12. INSTALL LOWER CENTER PILLAR GARNISH LH  (See INSTALLATION )
  13. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH  (See INSTALLATION )
  14. INSTALL LAP BELT OUTER ANCHOR COVER LH  (See INSTALLATION )
  15. INSTALL REAR DOOR SCUFF PLATE LH  (See INSTALLATION )
  16. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY  (See INSTALLATION )
  17. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  (See INSTALLATION )
  18. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
  19. INSTALL SIDE INSTRUMENT PANEL LH  (See INSTALLATION )
  20. INSTALL FRONT DOOR OPENING TRIM COVER LH  (See INSTALLATION )
  21. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
  22. INSTALL NO. 2 CONSOLE BOX DUCT  (See INSTALLATION )
  23. INSTALL CONSOLE BOX  (See INSTALLATION )
  24. INSTALL CONSOLE BOX REGISTER ASSEMBLY  (See INSTALLATION )
  25. INSTALL REAR ASH RECEPTACLE ASSEMBLY  (See INSTALLATION )
  26. INSTALL FRONT ASH RECEPTACLE ASSEMBLY  (See INSTALLATION )
  27. INSTALL CONSOLE PANEL SUB-ASSEMBLY  (See INSTALLATION )
  28. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH  (See INSTALLATION )
  29. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH  (See INSTALLATION )
  30. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY  (See INSTALLATION )
  31. INSTALL FRONT SEAT ASSEMBLY LH  (See INSTALLATION )
  32. INSTALL REAR INNER SEAT TRACK BRACKET COVER LH  (See INSTALLATION )
  33. INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH  (See INSTALLATION )
  34. INSTALL FRONT INNER SEAT TRACK BRACKET COVER LH  (See INSTALLATION )
  35. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER LH  (See INSTALLATION )
  36. INSTALL FRONT SEAT HEADREST ASSEMBLY 
  37. INSTALL REAR SEAT CUSHION ASSEMBLY  (See INSTALLATION )
  38. INSPECT FRONT SEAT ASSEMBLY  (See INSTALLATION )
  39. ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL  (See PARKING BRAKE SYSTEM )
  40. INSPECT BRAKE WARNING LIGHT  (See PARKING BRAKE SYSTEM )
  41. INSPECT SRS WARNING LIGHT 

    See DIAGNOSIS SYSTEM

scientia non olet · About LEMON Manuals