Section 77 (Engine Mechanical - 4.6L - 3 Of 4)
WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Off-Vehicle Repair Instructions (2 Of 3)
- Engine Block Cleaning and Inspection - Upper
- Engine Block Cleaning and Inspection - Lower
- Crankshaft and Bearings Cleaning and Inspection
- Crankshaft Balancer Cleaning and Inspection
- Engine Flywheel Cleaning and Inspection
- Piston and Connecting Rod Disassemble
- Piston, Connecting Rod, and Bearings Cleaning and Inspection
- Piston Cleaning Procedure
- Piston Inspection Procedure
- Piston Diameter Measurement Procedure
- Piston Pin Bore Measurement Procedure
- Piston Ring End Gap Measurement Procedure
- Piston Ring Side Clearance Measurement Procedure
- Connecting Rod Cleaning Procedure
- Connecting Rod Visual Inspection Procedure
- Connecting Rod Measurement Procedure
- Piston and Connecting Rod Assemble
- Camshaft Intermediate Drive Shaft Cleaning and Inspection
- Cylinder Head Disassemble
- Cylinder Head Cleaning and Inspection
- Valve Spring Inspection and Measurement
- Valve and Seat Grinding
- Valve Cleaning Procedure
- Valve Visual Inspection Procedure
- Valve Measurement and Reconditioning Overview
- Valve Seat Width Measurement Procedure
- Valve Seat Roundness Measurement Procedure
- Valve Margin Measurement Procedure
- Valve-to-Seat Concentricity Measurement Procedure
- Valve and Seat Reconditioning Procedure
- Valve Stem Height Measurement Procedure
- Cylinder Head Assemble
- Camshaft Cleaning and Inspection
- Valve Lifters Cleaning and Inspection
- Valve Rocker Arms Cleaning and Inspection
- Camshaft Timing Drive Components Cleaning and Inspection
- Oil Pump Disassemble
- Oil Pump Cleaning and Inspection
- Oil Pump Assemble
- Oil Filter Adapter Disassemble (without Oil Cooler)
- Oil Filter Adapter Disassemble (with Oil Cooler)
- Oil Filter Adapter Cleaning and Inspection (without Oil Cooler)
- Oil Filter Adapter Cleaning and Inspection (with Oil Cooler)
- Oil Filter Adapter Assemble (without Oil Cooler)
- Oil Filter Adapter Assemble (with Oil Cooler)
- Oil Pan Cleaning and Inspection
- Camshaft Cover Disassemble
- Camshaft Cover Cleaning and Inspection
- Camshaft Cover Assemble
- Intake Manifold Disassemble
- Intake Manifold Cleaning and Inspection
- Intake Manifold Assemble
- Exhaust Manifold Cleaning and Inspection - Left Side
- Exhaust Manifold Cleaning and Inspection - Right Side
- Water Crossover Disassemble
- Water Pump Cleaning and Inspection
- Water Crossover Cleaning and Inspection
- Water Crossover Assemble
- Thread Repair
- Service Prior to Assembly
- Engine Block Assemble - Upper
- Crankshaft and Bearings Installation
- Piston, Connecting Rod, and Bearing Installation
- Lower Crankcase Installation
- Oil Pump Pipe and Screen Assembly Installation
- Oil Pan Installation
- Cylinder Head Installation - Left Side
- Cylinder Head Installation - Right Side