LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Engine Mechanical - 4.6L - 3 Of 4) >> Off-Vehicle Repair Instructions (2 Of 3) >> Engine Flywheel Cleaning and Inspection >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Engine Flywheel
    GM483182Courtesy of GENERAL MOTORS CORP.
  1. Inspect the engine flywheel for the following conditions:
    • Stress cracks around the engine flywheel-to-torque converter mounting bolt hole locations (1) and/or engine flywheel-to-crankshaft (2, 4)
      • IMPORTANT: Do not attempt to repair the welded areas that retain the ring gear to the engine flywheel plate. Install a new engine flywheel.
    • Cracks at welded areas that retain the ring gear onto the engine flywheel (3)
    • Damaged or missing ring gear teeth (5)
  2. Replace the engine flywheel as necessary.
scientia non olet · About LEMON Manuals