Intake Manifold Assemble

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Intake Manifold Sight Shield Ball Studs

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the intake manifold sight shield ball studs.
Tighten: Tighten the intake manifold ball studs to 7 N.m (62 lb in).

Fig 2: Identifying Intake Manifold Plug

Courtesy of GENERAL MOTORS CORP.

Install the intake manifold plug.
Tighten: Tighten the intake manifold plug to 2 N.m (18 lb in).

Fig 3: Identifying Intake Manifold Vacuum Cap

Courtesy of GENERAL MOTORS CORP.

Install the vacuum cap.

Fig 4: View Of Intake Manifold-To-Cylinder Head Gaskets

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not reuse the intake manifold-to-cylinder head sealing gaskets.

Install NEW intake manifold-to-cylinder head gaskets.