Rear Seat Cushion Frame Replacement (Tahoe/Yukon/Escalade with Split Bench)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Seat Cushion Frame (Tahoe/Yukon/Escalade with Split Bench)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the rear seat. Refer to Rear Seat Replacement (Avalanche/Escalade EXT) , Rear Seat Replacement (Tahoe/Yukon/Escalade with Split Bench) , Rear Seat Replacement (Tahoe/Yukon/Escalade with Bucket Seat) . Remove the recliner handle. Refer to Rear Seat Recliner Handle Replacement (Tahoe/Yukon/Escalade with Bucket) . Remove the outer finish cover. Refer to Rear Seat Cushion Outer Trim Panel Replacement (with ARS) . Remove the inner finish cover. Refer to Rear Seat Cushion Inner Panel Replacement (Tahoe/Yukon/Escalade with Bucket) , Rear Seat Cushion Inner Panel Replacement (Tahoe/Yukon/Escalade with Split Bench) . Remove the cushion lower trim cover. Refer to Rear Seat Cushion Trim Panel Replacement (Tahoe/Yukon/Escalade with Split Bench) , Rear Seat Cushion Trim Panel Replacement (Tahoe/Yukon/Escalade with Bucket) , Rear Seat Cushion Trim Panel Replacement (Avalanche/Escalade EXT) . Remove the seat cushion cover and pad. Refer to Rear Seat Cushion Cover and Pad Replacement (Avalanche/Escalade EXT) , Rear Seat Cushion Cover and Pad Replacement (Tahoe/Yukon/Escalade with Split Bench) , Rear Seat Cushion Cover and Pad Replacement (Tahoe/Yukon/Escalade with Bucket) .
1	Rear Seat Recliner Bolt (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
2	Rear Seat Riser Outer Bolt (Qty: 2) Tighten 9 N.m (80 lb in)
3	Rear Seat Riser Inner Bolt Tighten 9 N.m (80 lb in)
4	Rear Seat Cushion Frame TIP: Disconnect the rear seat strut from the seat cushion frame.