Rear Seat Replacement (Avalanche/Escalade EXT)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Seat (Avalanche/Escalade EXT)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the jack access cover and jack from the vehicle. Remove the rear seat track finish cover.
1	Rear Seat Assembly Nut (Qty: 7) CAUTION: Refer to Fastener Caution . TIP: Remove the adjuster cover to access the nuts. Tighten 45 N.m (33 lb ft)
2	Rear Seat Belt Buckle Anchor Nut TIP: The nut is located behind the seat. Tighten 45 N.m (33 lb ft)
3	Rear Seat Assembly Procedure Disconnect the electrical connector, if equipped.