LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 301 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Rear Seat Cushion Cover and Pad Replacement (Avalanche/Escalade EXT)

Rear Seat Cushion Cover and Pad Replacement (Avalanche/Escalade EXT)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Seat Cushion Pad And Cover (Avalanche/Escalade EXT)
GM1708125Courtesy of GENERAL MOTORS CORP.
Rear Seat Cushion Cover and Pad Replacement (Avalanche/Escalade EXT)

Callout Component Name

Preliminary Procedure

  1. Unlatch the rear seat cushion and fold forward.
  2. Remove the rear seat back cushion latch covers. Refer to Rear Seat Back Cushion Latch Cover Replacement (Avalanche/Escalade EXT) .
  3. Remove the rear seat cushion trim panel. Refer to Rear Seat Cushion Trim Panel Replacement (Tahoe/Yukon/Escalade with Split Bench) , Rear Seat Cushion Trim Panel Replacement (Tahoe/Yukon/Escalade with Bucket) , Rear Seat Cushion Trim Panel Replacement (Avalanche/Escalade EXT) .
1 Rear Seat Cushion Cover
TIP:  Remove the seat cushion cover and pad as an assembly and then separate if needed.
2 Rear Seat Cushion Pad