LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Seat Hardware, Seat Trim And Upholstery) >> Repair Instructions >> Rear Seat Inner Recliner Replacement (Tahoe/Yukon/Escalade with Bucket)

Rear Seat Inner Recliner Replacement (Tahoe/Yukon/Escalade with Bucket)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Seat Inner Recliner Components
GM1890677Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the rear seat. Refer to Rear Seat Replacement (Tahoe with HP2)  or Rear Seat Replacement (Avalanche/Escalade EXT)  or Rear Seat Replacement (Tahoe/Yukon/Escalade with Split Bench)  or Rear Seat Replacement (Tahoe/Yukon/Escalade with Bucket Seat) .
  2. Remove the rear seat back cushion cover and pad. Refer to Rear Seat Back Cushion Cover and Pad Replacement (Tahoe/Yukon/Escalade with Bucket)  or Rear Seat Back Cushion Cover and Pad Replacement (Tahoe/Yukon/Escalade with Split Bench)  or Rear Seat Back Cushion Cover and Pad Replacement (Avalanche/Escalade EXT) .
  3. Remove the rear seat cushion cover and pad. Refer to Rear Seat Cushion Cover and Pad Replacement (Tahoe/Yukon/Escalade with Bucket)  or Rear Seat Cushion Cover and Pad Replacement (Tahoe/Yukon/Escalade with Split Bench)  or Rear Seat Cushion Cover and Pad Replacement (Avalanche/Escalade EXT) .
1 Rear Seat Recliner Bolt (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:  50 N.m (37 lb ft)

2 Rear Seat Inner Recliner

Procedure

  1. Note the routing of the recliner cables for installation.
  2. Disconnect the recliner cables from the recliner assembly.