Rear Seat Replacement (Avalanche/Escalade EXT)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat Assembly & Nuts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the jack access cover and jack from the vehicle. Remove the rear seat track finish cover.
1	Rear Seat Assembly Nut (Qty: 7) NOTE: Refer to Fastener Notice . Tip: Remove the adjuster cover to access the nuts. Tighten: 45 N.m (33 lb ft)
2	Rear Seat Belt Buckle Anchor Nut Tip: The nut is located behind the seat. Tighten: 45 N.m (33 lb ft)
3	Rear Seat Assembly Procedure: Disconnect the electrical connector, if equipped.