LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Cellular, Entertainment, And Navigation >> Repair Instructions >> Cellular Communications/Digital Radio Antenna Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Antenna Base & Cables
    GM853340Courtesy of GENERAL MOTORS CORP.
    NOTE: DO NOT apply paint or clear coat to the antenna. This will damage the function of the antenna, causing poor reception or loss of signal reception.
  1. Remove the windshield side garnish molding. Refer to Windshield Side Garnish Molding Replacement .
  2. Remove the sunshade from the headliner. Refer to Sunshade Replacement .
  3. Remove the center pillar upper garnish molding. Refer to Center Pillar Upper Garnish Molding Replacement .
    4. IMPORTANT: Complete removal of the headliner is not required.
  4. Lower the front corner of the headliner. Refer to Headlining Trim Panel Replacement (SUT) or Headlining Trim Panel Replacement (SUV) .
    5. Fig 2: Identifying Retaining Nut Of Antenna Assembly
    GM838978Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the wire harness to the roof antenna.
  6. Remove the antenna fastener.
  7. Remove the antenna from the roof.
scientia non olet · About LEMON Manuals