LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 163 (Engine Mechanical - 3.6L (LGX LF4) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Replacement (LGX, RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine to the transmission. Transmission Replacement (M5N with LGX Engine)
  2. Place the powertrain and frame assembly on the engine support table.
  3. Secure the powertrain to the support table using straps and binders.
  4. With the aid of an assistant, carefully lower the body onto the powertrain assembly.
  5. Ensure when lowering the body the following items are clear from the frame:
    • Vacuum lines
    • Steering knuckles
    • Electrical wiring harnesses
    • Oil cooler lines
  6. Install the drivetrain and front suspension cradle with the powertrain attached. Drivetrain and Front Suspension Cradle Replacement (LGX, LTG)
  7. Remove the engine support table.
  8. Complete installation of the transmission. Transmission Replacement (M5N with LGX Engine)
  9. Install Catalytic Converter - Catalytic Converter Replacement - Left Side (LGX) , and Catalytic Converter Replacement - Right Side (LGX)
  10. Connect Electrical Connector@Air Conditioning Refrigerant Pressure Sensor - Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement (LF4, LGX)
    11. Fig 1: Electrical Connector
    GM4512201Courtesy of GENERAL MOTORS COMPANY
  11. Attach the transmission control harness retainer (2) to the bracket.
  12. Connect Electrical Connector (1) @Transmission Control Module - Transmission Control Module Replacement
  13. Install Engine Lower Front Splash Shield - Front Wheelhouse Splash Shield Replacement (Rear Wheel Drive)
  14. Install Front Compartment Lower Noise Shield - Front Compartment Lower Noise Shield Replacement (Front Wheel Drive)Front Compartment Lower Noise Shield Replacement (All Wheel Drive)
  15. Lower the vehicle.
    16. Fig 2: Harness Connector
    GM4621733Courtesy of GENERAL MOTORS COMPANY
  16. Position the harness (2)
  17. Connect Harness Connector (1)
  18. Connect Transmission Fluid Cooler Pipe@Radiator Assembly- Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LGX With RWD, Without V03)Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LGX With RWD, With V03)
    19. Fig 3: Air Conditioning Compressor Hose
    GM4088992Courtesy of GENERAL MOTORS COMPANY
  19. Connect Air Conditioning Compressor Hose (1) @Air Conditioning Compressor- Air Conditioning Compressor Hose Replacement (LGX)
    20. Fig 4: Power Brake Booster Vacuum Sensor
    GM4066216Courtesy of GENERAL MOTORS COMPANY
  20. Connect Power Brake Booster Vacuum Hose (1) @Power Brake Booster
  21. Connect Power Brake Booster Vacuum Sensor@Power Brake Booster Vacuum Hose (1)
  22. Install Evaporative Emission Canister Purge Tube - Evaporative Emission Canister Purge Tube Replacement (LGX)
    23. Fig 5: Fuel Line At Fuel Feed Pipe
    GM4167305Courtesy of GENERAL MOTORS COMPANY
  23. Connect Fuel Line (1) @Fuel Feed Pipe - Fuel Feed Pipe Replacement (Fuel Tank To Engine LGX)Fuel Feed Pipe Replacement (LGX at Engine)
    24. Fig 6: Heater Outlet Hose
    GM4167273Courtesy of GENERAL MOTORS COMPANY
  24. Heater Outlet Hose (1) @Radiator Surge Tank
  25. Heater Outlet Hose (1) @Heater Core
    26. Fig 7: Heater Inlet Hose
    GM4167258Courtesy of GENERAL MOTORS COMPANY
  26. Connect Heater Inlet Hose (1) @Heater Core
  27. Remove mechanics wire that supported the radiator assembly to the vehicle body.
  28. Reposition and connect harnesses as necessary.
    29. Fig 8: Radiator Outlet Hose
    GM4105036Courtesy of GENERAL MOTORS COMPANY
  29. Radiator Outlet Hose (1) @Water Pump
    30. Fig 9: Radiator Surge Tank Inlet Hose (LGX)
    GM4092953Courtesy of GENERAL MOTORS COMPANY
  30. Radiator Surge Tank Inlet Hose (1) @Engine Coolant Air Bleed Pipe
    31. Fig 10: Radiator Inlet Hose (LGX)
    GM4093189Courtesy of GENERAL MOTORS COMPANY
  31. Connect Radiator Inlet Hose (2) @Water Outlet
  32. Position the engine harness.
  33. Install Engine Control Module Bracket - Engine Control Module Bracket Replacement (LGX)
    34. Fig 11: Engine Control Module Electrical Connector
    GM4167076Courtesy of GENERAL MOTORS COMPANY
  34. Install the battery terminal (1) to the jump start post.
  35. Install the air cleaner assembly. Air Cleaner Assembly Replacement (LGX)
  36. Install the front compartment front sight shield. Front Compartment Front Sight Shield Replacement (Sedan)Front Compartment Front Sight Shield Replacement (Coupe)Front Compartment Front Sight Shield Replacement (ATS-V)
  37. Install Intake Manifold Insulator - Intake Manifold Insulator Replacement (LGX) 
  38. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
  39. Fill the cooling system. Cooling System Draining and Filling (Static)Cooling System Draining and Filling (GE 47716)
  40. Fill the engine oil to the proper level with NEW engine oil. Engine Oil and Oil Filter Replacement (LGX, RWD) 
    41. NOTE:

    Prelube is necessary if the engine is replaced or overhauled.

  41. If the engine is replaced with a new engine or has been overhauled, perform the Engine Prelubing procedure. Engine Prelubing
  42. Charge the A/C system. Refrigerant Recovery and Recharging (R-134a)Refrigerant Recovery and Recharging (R-1234yf)
  43. Perform the throttle learn procedure. Throttle or Idle Learn (LGX)
scientia non olet · About LEMON Manuals