Symptom Chart: Information And Message Center - Warnings
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
Symptom Chart
| Condition | Possible Sources | Actions |
|---|---|---|
| The BLIS/ CTA warning message is never or always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test J |
| A brake warning (brake fluid level low, parking brake applied or brake system malfunction) message is never displayed | Refer to the Pinpoint Test | GO to Pinpoint Test K |
| A brake warning (brake fluid level low, parking brake applied or brake system malfunction) message is always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test L |
| The charge port door ajar message is always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test AT |
| The charging system (high voltage) warning message is always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test AS |
| The destination alert (not enough for destination) warning message is never or always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test AO |
| The distance to empty (electric range) warning message is never or always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test AO |
| A door, hood compartment or liftgate ajar warning message is never or always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test O |
| The electric park brake fault message is always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test P |
| The ignition-engine on (vehicle is on) warning message is never or always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test AU |
| The hazard (system failure) warning message is never or always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test R |
| The limited/severely limited performance warning message is always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test Y |
| A load shed warning message is always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test M |
| The low washer fluid level warning message is always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test Z |
| The rear seatbelt monitor warning message is never or always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test AE |
| The seatbelt buckle message is never or always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test AF |
| Service AdvanceTrac® warning message is always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test AH |
| A TPMS malfunction message is always displayed | Refer to the Pinpoint Test | GO to Pinpoint Test AJ |
| The tire training complete message is never on (sensor training incomplete) | Refer to the Pinpoint Test | GO to Pinpoint Test AV |
| A tire training message (train left front, right front, left rear or right rear tire) message is never on | Refer to the Pinpoint Test | GO to Pinpoint Test AV |
| The tires not trained message is always on | Refer to the Pinpoint Test | GO to Pinpoint Test AV |