Pinpoint Test At: The Charge Port Door Ajar Message Is Never Or Always Displayed

Normal Operation and Fault Conditions
See Charge Port Door Ajar Message. REFER to: Message Center - System Operation and Component Description .

If the charge port door ajar status message is missing for less than 5 seconds, the IPC defaults the charge port door ajar message to the last indication state, based upon the last message received.

If the charge port door ajar status message is missing for 5 seconds or longer, the IPC defaults the charge port door ajar message off.

Possible Sources
- GWM
- SOBDM
- IPC

AT1 VERIFY MESSAGE CENTER OPERATION
- Verify with the customer the near navigation feature display functions correctly.
Does the near navigation feature display function correctly?

Yes GO to AT2

No GO to Pinpoint Test A

AT2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to Diagnostic Trouble Code (DTC) Chart .

No GO to AT3

AT3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).

Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes	REFER to: Controller Area Network (CAN) Module Communications Network .

If the charge port door ajar message is never on, the system is operating correctly at this time. There are currently no vehicle concerns present that require the charge port door ajar message display. If the charge port door ajar message is always on, DIAGNOSE all SOBDM Diagnostic Trouble Codes (DTCs). REFER to Diagnostic Trouble Code (DTC) Chart .