Anti-Theft System - Passive Anti-Theft System - With Intelligent Access

• Specifications
  • Passive Anti-Theft System (PATS) - with Intelligent Access (IA)
    • Torque Specifications
• Description And Operation
  • Passive Anti-Theft System (PATS) - with Intelligent Access (IA)
    • Component Location
    • Overview
    • System Operation
      • System Diagram
      • Network Message Chart
      • Passive Anti-Theft System (PATS)
        • Notes
        • PATS PIDs
      • Backup Starting
      • No Key Detected Message
    • Component Description
      • Passive Start Antennas
      • Interior Passive Start Antenna Ranges
      • Backup Transceiver
      • Intelligent Access (IA) Key
      • Tire Pressure Monitor (TPM) Module
      • Start-Stop Switch
      • Remote Function Actuator (RFA)
      • Body Control Module (BCM)
• DTC And Symptom Chart(S)
  • Related Module DTC Chart(s)
  • Symptom Chart(s)
    • Symptom Chart: Passive Anti-Theft System (PATS)
• Diagnostic Routine(S)
  • Diagnostic Routine A
    • Diagnostic Overview
      • B10D7:05
        • Normal Operations and Fault Conditions
        • Visual Inspection and Diagnostic Pre-checks
    • Pinpoint Test
  • Diagnostic Routine B
    • Diagnostic Overview
      • B10D9:11, B10D9:12, B10D9:31 Or B10D9:87
      • Normal Operations and Fault Conditions
    • Pinpoint Test
  • Diagnostic Routine C
    • Diagnostic Overview
      • U201F:31
      • Normal Operations and Fault Conditions
    • Pinpoint Test
  • Diagnostic Routine D
    • Diagnostic Overview
      • The Vehicle Does Not Start With the Intelligent Access (IA) Key in Certain Areas of the Vehicle
      • Normal Operations and Fault Conditions
    • Special Tool(s)
    • Pinpoint Test
  • Diagnostic Routine E
    • Diagnostic Overview
      • The Engine Does Not Start or Unable To Turn Ignition On
        • Normal Operations and Fault Conditions
    • Pinpoint Test
  • Diagnostic Routine F
    • Diagnostic Overview
      • A No Key Detected Message Is Displayed In The Message Center
        • Normal Operations and Fault Conditions
    • Pinpoint Test
• General Procedures
  • Erase All Keys and Program Two Keys
    • General Procedure
  • Key Programming Using Diagnostic Equipment
    • General Procedure
  • Key Programming Using Two Programmed Keys
    • General Procedure
  • Enable or Disable Spare Key Programming
    • General Procedure
  • Passive Anti-Theft System (PATS) Parameter Reset
    • General Procedure
• Removal And Installation
  • Backup Transceiver
    • Exploded View
    • Removal
    • Installation
  • Passive Start Antenna - Front
    • Exploded View
    • Removal
    • Installation
  • Passive Start Antenna - Center
    • Exploded View
    • Removal
    • Installation
  • Passive Start Antenna - Rear
    • Exploded View
    • Removal
    • Installation