Start-Stop Switch

The start/stop switch is a momentary contact switch that is hardwired to the RFA module, BCM, and the PCM. When the switch is pressed, it signals the RFA module, BCM, and the PCM that there is a request to either switch the ignition on or start the engine. The start/stop switch is connected to both the RFA module and BCM as a backup in case of a failure. If there is a circuit failure to either module from the start/stop switch, the modules communicate the start/stop switch request to each other over the MS-CAN  .

If the vehicle is running and moving at a speed greater than 8 kmh (5 mph), the engine can be shut down by pressing the start/stop switch 3 times within 2 seconds.