Special Tools
WARNING: This page is about a different variant/trim than selected.
- DT-48056 Spring Compressor Bridge
- DT-50902 Adjustable Clutch Spring Compressor
- DT-50903 Clutch Travel Load Gauge
- DT-51328 Clutch Compressor and Air Travel Check Rod Extension
- GE-8001 Dial Indicator Set
Equivalent regional tools: Special Tools
- Install the case extension assembly. Case Extension Assembly Installation NOTE:
For 8L45 models only, prior to performing the 1-2-3-4-5 Reverse Clutch Backing Plate Retaining Ring Measurement, ensure the Rear Output Shaft, Output Carrier, and Reaction Carrier are removed, if previously installed, to prevent interference with the measuring tools.
- Install the 1-2-3-4-5 reverse clutch plate assembly. Reaction Internal Gear and 1-2-3-4-5 Reverse Hub and 1-2-3-4-5 Reverse Clutch Plate Assembly Installation
Assemble the tools as shown and apply 80 pounds of pressure to the load gauge by turning the screw on the DT-48056 Spring Compressor Bridge clockwise.
- Zero out the dial indicator.
- Remove the pressure on the load gauge by turning the screw on the DT-48056 Spring Compressor Bridge one full turn counterclockwise.
- Apply 345 kPa (50 psi) of compressed air to the indicated case passage and simultaneously adjust the screw on the DT-48056 Spring Compressor Bridge to apply 80 pounds of pressure to the load gauge.
- Observe the dial indicator measurement. Refer to Clutch Backing Plate Retaining Ring Specifications (8L45) to determine the correct 1-2-3-4-5 reverse clutch backing plate retaining ring.
CAUTION:
Regulate the air pressure to 345 kPa (50 psi) maximum. High pressure could cause the piston to over travel and damage the piston seals.