Fastener Specifications (Off-Vehicle)
WARNING: This page is about a different variant/trim than selected.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Automatic Transmission Auxiliary Fluid Pump Seal |
| Automatic Transmission Fluid Filter |
| Automatic Transmission Fluid Level Control Valve Seal |
| Automatic Transmission Fluid Pressure Sensor Seal |
| Automatic Transmission Fluid Pump Pressure Plate Seal |
| Automatic Transmission Fluid Temperature Sensor Seal |
| Automatic Transmission Wiring Connector Seal |
| Control Valve Body Spacer Plate Retainer |
| Control Valve Body Cover Wiring Connector Hole Seal |
| Driven Sprocket Retaining Ring |
| Front Wheel Drive Shaft Oil Seal |
| Forward Clutch Housing Fluid Seal Ring |
| Forward Clutch Piston Dam Retaining Ring |
| Manual Shift Detent Lever Hub Pin |
| Manual Shift Shaft Seal |
| Reverse Clutch Piston Inner Seal |
| Reverse Clutch Piston Outer Seal |
| Torque Converter Fluid Seal |
| Torque Converter Fluid Seal Ring |
| Transmission Fluid Cooler Pipe Fitting Seal |
| Turbine Shaft Fluid Seal Ring |
| Turbine Shaft Seal |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
||||
|---|---|---|---|---|
| Application | Ref No.* | Quantity | Size | Specification |
| Metric (English) | ||||
| Automatic Transmission Fluid Filter | 1 | 1 | - | 60 N.m (44 lb ft) |
| Automatic Transmission Speed Sensor Bolt | 69 | 1 | M6x25 | First Pass: 4 N.m (35 lb in) Final Pass: 45 Degrees |
| Front Differential Carrier Baffle Bolt | 22 | 2 | M6x25 | First Pass: 4 N.m (35 lb in) Final Pass: 45 Degrees |
| Manual Shift Detent Lever Spring Bolt | 401 | 1 | M6x25.65 | 9 N.m (80 lb in) |
| Torque Converter and Differential Housing Bolt | 18 | 13 | M8x30 | Torque Converter and Differential Housing Installation |
| Torque Converter and Differential Housing Bolt | 26 | 5 | M10x35 | Torque Converter and Differential Housing Installation |
| *Reference number refers to the component callout number in Disassembled Views | ||||
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
||||
|---|---|---|---|---|
| Application | Ref No.* | Quantity | Size | Specification |
| Metric (English) | ||||
| Automatic Transmission Auxiliary Fluid Pump Bolt | 190 | 3 | M5x33 | 4.7 N.m (42 lb in) |
| Automatic Transmission Auxiliary Fluid Pump Bolt | 191 | 1 | M5x50 | 4.7 N.m (42 lb in) |
| Automatic Transmission Auxiliary Fluid Pump Bolt | 182 | 1 | M5x20 | 4.7 N.m (42 lb in) |
| Automatic Transmission Case Cover Plug | 80 | 1 | 1/8"-27 NPTF | 10.5 N.m (93 lb in) |
| Automatic Transmission Case Cover Plug | 83 | 2 | M12x1.5 | 16 N.m (12 lb ft) |
| Automatic Transmission Case Hole Plug | 71 | 4 | 1/8"-27 NPTF | 10.5 N.m (93 lb in) |
| Automatic Transmission Case Hole Plug | 14 | 2 | 1/8"-27 NPTF | 10.5 N.m (93 lb in) |
| Automatic Transmission Fluid Level Hole Plug | 50 | 1 | M12x1.25 | 2 N.m (18 lb in) |
| Automatic Transmission Fluid Pump Cover Bolt | 167 | 7 | M6x65 | 10 N.m (89 lb in) |
| Automatic Transmission Fluid Pump Cover Bolt | 180 | 2 | M6x30 | 10 N.m (89 lb in) |
| Control Valve Body Cover Bolt | 52 | 4 | M6x30 | 9 N.m (80 lb in) |
| Control Valve Body Cover Stud | 51 | 8 | M6x1 | 9 N.m (80 lb in) |
| Stator Shaft Support Bolt | 103 | 8 | M6x35 | Automatic Transmission Fluid Pump Installation |
| Valve Body Bolt | 59 | 7 | M5x70 | Control Valve Body Assembly Installation |
| Valve Body Bolt | 60 | 11 | M5x85 | Control Valve Body Assembly Installation |
| Valve Body Bolt | 61 | 2 | M5x98.3 | Control Valve Body Assembly Installation |
| Valve Body Bolt | 64 | 2 | M5x55 | Control Valve Body Assembly Installation |
| Valve Body Bolt | 65 | 7 | M5x100 | Control Valve Body Assembly Installation |
| Valve Body Bolt | 204 | 4 | M5x30 | Control Valve Body Assemble |
| Wiring Harness Bracket Bolt | 2 | 3 | M6x25 | 9 N.m (80 lb in) |
| Wiring Harness Connector Bolt | 56 | 2 | M5x25 | 8 N.m (71 lb in) |
| Wiring Harness Connector Bolt | 93 | 1 | M5x20 | 8 N.m (71 lb in) |
| *Reference number refers to the component callout number in Disassembled Views | ||||