Control Valve Body Assembly Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Control Valve Body Installation

Callout	Component Name
1	Control Valve Body Locating Pin [2x]
2	Control Valve Body Procedure Install control valve body on case. Align the manual shift detent lever in the groove of the manual valve.
3	Valve Body Bolt [2x] M5 x 55 CAUTION: Refer to Fastener Caution . Tighten 8 N.m (71 lb in)

Callout

Component Name

Control Valve Body Locating Pin [2x]

Control Valve Body

Procedure

Valve Body Bolt [2x] M5 x 55

CAUTION:

Tighten
8 N.m (71 lb in)

Fig 1: Exploded View Of Control Valve Solenoid Body Components And Bolt Identification

Courtesy of GENERAL MOTORS COMPANY

Control Valve Solenoid Body Installation

Callout	Component Name
1	Control Valve Solenoid Body
2	Automatic Transmission Fluid Pressure Sensor Seal [2x] Procedure The seal is reusable, inspect the seal and replace if damaged.
3	Automatic Transmission Fluid Pressure Sensor [2x]
4	Valve Body Bolt [7x] M5 x 70 Procedure Hand tighten and follow torque sequence below.
5	Valve Body Bolt [7x] M5 x 100 Procedure Hand tighten and follow torque sequence below.
6	Valve Body Bolt [11x] M5 x 85 Procedure Hand tighten and follow torque sequence below.
7	Valve Body Bolt [2x] M5 x 98.3 Procedure Hand tighten and follow torque sequence below.

Fig 2: Identifying Control Valve Solenoid Body Bolts With Tightening Sequence

Courtesy of GENERAL MOTORS COMPANY

Control Valve Solenoid Body Torque Sequence

Callout	Component Name
1	Valve Body Bolt [7x] M5 x 70 Tighten in sequence 8 N.m (71 lb in)
2	Valve Body Bolt [7x] M5 x 100 Tighten in sequence 8 N.m (71 lb in)
3	Valve Body Bolt [11x] M5 x 85 Tighten in sequence 8 N.m (71 lb in)
4	Valve Body Bolt [2x] M5 x 98.3 Tighten in sequence 8 N.m (71 lb in)

Fig 3: Exploded View Of Automatic Transmission Wiring Harness Components

Courtesy of GENERAL MOTORS COMPANY

Automatic Transmission Wiring Harness Installation

Callout	Component Name
1	Automatic Transmission Fluid Temperature Sensor Seal Procedure Install a NEW seal. Do NOT reuse the old seal.
2	Automatic Transmission Wiring Harness Procedure Install the wiring harness. Connect the harness connectors. Slide connector lock as indicated by arrow.
3	Wiring Harness Connector Bolt [2x] M5 x 25 Tighten 8 N.m (71 lb in)
4	Wiring Harness Connector Bolt M5 x 20 Tighten 8 N.m (71 lb in)