No Reverse Gear
WARNING: This page is about a different variant/trim than selected.
| Checks |
Action |
| Input Shaft on the Forward Clutch Assembly (106) |
Inspect for a broken tooth. Replace the forward clutch housing assembly (302). Forward Clutch Assembly Disassemble |
| Forward Clutch Assembly (106) |
Inspect for:
- Damaged reverse internal gear (313) and retaining ring (314).
- Damaged reverse sun gear assembly (308)
- Damaged or worn reverse sun gear thrust bearing (307)
Forward Clutch Assembly Disassemble |
| Reverse Clutch Assembly |
Inspect for:
- Damaged or worn splines of the reverse clutch backing plate (112)
- Broken or damaged backing plate retaining ring (111)
- Damaged or worn splines of the reverse clutch plate (114), apply plate (115) and waved plate (116)
- Worn splines or friction material in the reverse clutch plate assemblies (113)
- Damaged or worn reverse carrier assembly (108) and thrust washers (107)
- Damaged or worn reverse clutch spring assembly (110) and retaining ring (109)
- Damaged reverse clutch spring assembly (119) and worn seals (117, 118)
Reverse Carrier Removal
, or Reverse Clutch Spring Removal
, or Reverse Clutch Plate and Reverse Clutch Piston Removal |
| Manual Valve (234) |
Inspect for wear, sticking or binding. Control Valve Solenoid Body Cleaning and Inspection |