LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Automatic Transmission - 5ET50 (MKE)) >> Repair Instructions - On Vehicle >> Drive Motor Power Inverter Module Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Drive Motor Power Inverter Module Cover Installation  (2) - Install
    Fig 1: Drive Motor Power Inverter Module Cover And Components
    GM4037211Courtesy of GENERAL MOTORS COMPANY
  2. Drive Motor Battery Positive and Negative Cable Connector (2) - Install
    Fig 2: Drive Motor Battery Positive And Negative Cable Connector And Bolts (With Bolt Tightening Sequence)
    GM4230936Courtesy of GENERAL MOTORS COMPANY
  3. Drive Motor Battery Positive and Negative Cable Connector Bolt (1) - Tighten in sequence [4x] 9 N.m (80 lb in)
    CAUTION: Fastener Caution
  4. Connect the transmission electrical connector (2).
    Fig 3: Transmission Electrical Connector
    GM4283325Courtesy of GENERAL MOTORS COMPANY
  5. Connect the transmission high voltage electrical connectors (3).
  6. Connect the radiator surge tank overflow hose (1).
  7. Install the transmission mount transmission side bracket. Refer to Transmission Mount Transmission-Side Bracket Replacement 
  8. Install the secondary shield (2) to the transmission.
    Fig 4: Transmission Secondary Shield
    GM4283170Courtesy of GENERAL MOTORS COMPANY
  9. Install the primary shield (3) to the transmission.
    Fig 5: Transmission Primary Shield
    GM4258126Courtesy of GENERAL MOTORS COMPANY
  10. Install the range selector lever cable bracket. Refer to Range Selector Lever Cable Bracket Replacement 
  11. Range Selector Lever Cable Adjustment  - Adjust
  12. Drive Motor Generator Power Inverter Module Cooling System Draining and Filling - Fill
  13. Enable the high voltage system and connect the A4 Hybrid/EV Battery Pack high voltage harness connector at the T6 Power Inverter Module. Refer to High Voltage Enabling .
  14. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (without KL9)Battery Negative Cable Disconnection and Connection (with KL9)
scientia non olet · About LEMON Manuals