LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Automatic Transmission - 5ET50 (MKE)) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Adjustment

Range Selector Lever Cable Adjustment

WARNING: This page is about a different variant/trim than selected.
  1. Set the parking brake.
  2. Verify the transmission control lever is in the Park position.
    NOTE: Adjust the automatic transmission range selector lever cable while the transmission and the transmission control are in the Park position only. Failure to do so may cause false adjustment.
  3. Verify the range selector lever is in the Park position.
  4. Pull the retaining collar (1) forward, then release the range select cable adjuster clip (2) by pushing out on the adjuster clip from the underneath.
    Fig 1: Retaining Collar And Range Select Cable Adjuster Clip
    GM4117407Courtesy of GENERAL MOTORS COMPANY
  5. Depress the adjuster clip (2) locking the adjuster clip completely, then release the retaining collar (1).
    Fig 2: Retaining Collar And Adjuster Clip
    GM4117408Courtesy of GENERAL MOTORS COMPANY
  6. Ensure that the cable adjuster is secured.
    WARNING: After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.
  7. Check the transmission control lever in all gear selections for proper operation.
scientia non olet · About LEMON Manuals