Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Brake Pressure Modulator Valve Bracket (1) - Install Brake Pressure Modulator Valve Bracket Replacement

Fig 1: Brake Pressure Modulator Valve Bracket
Courtesy of GENERAL MOTORS COMPANY
Electronic Brake Control Module with Brake Pressure Modulator Valve - Install
Brake Pressure Modulator Valve Bracket Bolt (1) - Install and tighten 9 N.m (80 lb in)

Fig 2: Brake Pressure Modulator Valve Bracket Bolt
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Fastener Caution
Brake Pressure Modulator Valve Bracket Nut (1) - Install and tighten 9 N.m (80 lb in)

Fig 3: Brake Pressure Modulator Valve Bracket Nut
Courtesy of GENERAL MOTORS COMPANY
Brake Pressure Modulator Valve Bracket Nut (1) - Tighten 9 N.m (80 lb in)

Fig 4: Brake Pressure Modulator Valve Bracket Nut
Courtesy of GENERAL MOTORS COMPANY
Brake Pressure Modulator Valve Primary Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)

Fig 5: Brake Pressure Modulator Valve Primary Pipe Fitting
Courtesy of GENERAL MOTORS COMPANY
Brake Pressure Modulator Valve Secondary Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)

Fig 6: Brake Pressure Modulator Valve Secondary Pipe Fitting
Courtesy of GENERAL MOTORS COMPANY
Left Front Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)

Fig 7: Left Front Brake Pipe Fitting
Courtesy of GENERAL MOTORS COMPANY
Right Front Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)

Fig 8: Right Front Brake Pipe Fitting
Courtesy of GENERAL MOTORS COMPANY
Left Rear Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)

Fig 9: Left Rear Brake Pipe Fitting
Courtesy of GENERAL MOTORS COMPANY
Right Rear Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)

Fig 10: Right Rear Brake Pipe Fitting
Courtesy of GENERAL MOTORS COMPANY
Brake Master Cylinder Hose Brake Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)

Fig 11: Brake Master Cylinder Hose Brake Pipe Fitting
Courtesy of GENERAL MOTORS COMPANY
Connect the EBCM electrical connector.
Radiator Surge Tank Replacement (LFV)Radiator Surge Tank Replacement (LTG)Radiator Surge Tank Replacement (LKN) - Install
High Voltage - Enable High Voltage Enabling
Program the EBCM. Control Module References
Center the steering angle sensor. Refer to Steering Wheel Angle Sensor Centering
Bleed the brake system. Refer to Antilock Brake System Automated Bleed