Radio Speaker Amplifier Replacement (Cadillac)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Radio Speaker Amplifier Assembly And Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the floor console bezel. Refer to Floor Console Bezel Replacement (Except Cadillac) , Floor Console Bezel Replacement (Cadillac) . Remove the front floor console side trim front panel - Left. Refer to Front Floor Console Side Trim Front Panel Replacement - Left Side (Cadillac) . Remove the front floor console side trim front panel - Right. Refer to Front Floor Console Side Trim Front Panel Replacement - Right Side (Cadillac) .
1	Front Floor Console Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
2	Front Floor Console Rear Screw (Qty: 2) TIP: Open the rear cupholder to access the screws. Tighten 2 N.m (18 lb in)
3	Front Floor Console Lower Screw (Qty: 4) Procedure Move the seats forward or rearward to access the screws as needed. Rotate the upper portion of the console assembly rearward to access the amplifier. Tighten 9 N.m (80 lb in)
4	Amplifier Screw (Qty: 4) Tighten 9 N.m (80 lb in)
5	Radio Speaker Amplifier Assembly Procedure Disconnect the electrical connectors. For programming and set up, refer to Control Module References .