Daytime Running Lamp Replacement (RS)

Preliminary Procedures

1. Remove the front wheel liner. Refer to Front Wheelhouse Liner Replacement (Base, RS, SS) , Front Wheelhouse Liner Replacement (ZL1) .
2. Disconnect the electrical connector from the daytime running lamp bulb socket.
3. Remove the fog lamp bezel. Refer to Front Fog Lamp Bezel Replacement , Front Fog Lamp Bezel Replacement (ZL1) .

Procedure

1. Using a 10 mm, six point socket, push outward and release each of the daytime running lamp tabs from the front bumper fascia opening.
2. Position and press the lamp assembly back into the front bumper fascia opening until all three lamp assembly tabs are secure to the front bumper fascia.