Section 1125 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L (4 Of 5))
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Off-Vehicle Repair Information (2 Of 3)
- Cylinder Boring and Honing
- Crankshaft and Bearing Cleaning and Inspection
- Crankshaft Balancer Cleaning and Inspection
- Automatic Transmission Flex Plate Cleaning and Inspection
- Piston and Connecting Rod Disassemble
- Piston, Connecting Rod, and Bearing Cleaning and Inspection
- Piston and Connecting Rod Assemble
- Camshaft Bearing Removal
- Camshaft and Bearings Cleaning and Inspection (RPO LY2/LH6/LMG/LY5/LC9)
- Camshaft and Bearings Cleaning and Inspection (RPO LY6/L76/L92)
- Camshaft Bearing Installation
- Camshaft Timing Chain and Sprocket Cleaning and Inspection
- Camshaft Position Actuator Cleaning and Inspection
- Camshaft Position Actuator Magnet Cleaning and Inspection
- Camshaft Position Actuator Solenoid Valve Inspection (On-Vehicle)
- Camshaft Position Actuator Solenoid Valve Inspection (Off-Vehicle)
- Valve Rocker Arm and Push Rod Cleaning and Inspection
- Valve Lifters and Guides Cleaning and Inspection (RPO LY2/LY6/L92)
- Valve Lifters and Guides Cleaning and Inspection (RPO LH6/LMG/LY5/LC9/L76)
- Cylinder Head Disassemble
- Cylinder Head Cleaning and Inspection
- Valve Guide Reaming, and Valve and Seat Grinding
- Cylinder Head Assemble
- Oil Pump Disassemble
- Oil Pump Cleaning and Inspection
- Oil Pump Assemble
- Engine Front Cover Cleaning and Inspection (RPO LY2/LH6/LMG/LY5/LC9)
- Engine Front Cover Cleaning and Inspection (RPO LY6/L76/L92)
- Crankshaft Rear Oil Seal Housing Cleaning and Inspection
- Engine Block Valley Cover Cleaning and Inspection
- Valve Lifter Oil Manifold Cleaning and Inspection
- Valve Rocker Arm Cover Cleaning and Inspection
- Oil Pan Cleaning and Inspection
- Intake Manifold Cleaning and Inspection
- Exhaust Manifold Cleaning and Inspection
- Engine Coolant Air Bleed Pipe and Hole Cover Cleaning and Inspection
- Water Pump Cleaning and Inspection
- Thread Repair
- Service Prior to Assembly
- Engine Block Plug Installation
- Crankshaft and Bearing Installation
- Piston, Connecting Rod, and Bearing Installation
- Camshaft Installation
- Camshaft Position Actuator and Solenoid Valve Installation
- Timing Chain and Sprockets Installation
- Oil Pump, Screen and Crankshaft Oil Deflector Installation (RPO LY2/LH6/LMG/LY5/LC9)
- Oil Pump, Screen and Crankshaft Oil Deflector Installation (RPO LY6/L76/L92)
- Crankshaft Rear Oil Seal Housing Installation (With Seal in Housing)
- Crankshaft Rear Oil Seal Housing Installation (Without Seal in Housing)
- Crankshaft Rear Oil Seal Installation