LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1125 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L (4 Of 5)) >> Off-Vehicle Repair Information (2 Of 3) >> Engine Coolant Air Bleed Pipe and Hole Cover Cleaning and Inspection

Engine Coolant Air Bleed Pipe and Hole Cover Cleaning and Inspection

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Coolant Air Bleed Pipe Seal
    GM1552485Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not use the engine coolant air bleed pipe and cover seals again. Upon installation of the pipe and covers, install NEW seals.
  1. Remove the seals (308) from the pipe and covers.
    2. Fig 2: View Of Coolant Air Bleed Pipe Components
    GM1658230Courtesy of GENERAL MOTORS CORP.
  2. Clean the pipe and covers in solvent.
    3. CAUTION: Refer to Safety Glasses and Compressed Air Caution .
  3. Dry the pipe and covers with compressed air.
  4. Inspect the pipe and covers for restrictions within the pipe (1) or damaged sealing surfaces (2, 3).
scientia non olet · About LEMON Manuals