LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1125 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L (4 Of 5)) >> Off-Vehicle Repair Information (2 Of 3) >> Intake Manifold Cleaning and Inspection >> Cleaning Procedure

Cleaning Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake Manifold-To-Cylinder Head Gasket
    GM1277097Courtesy of GENERAL MOTORS CORP.
  1. Remove and discard the intake manifold-to-cylinder head gaskets (514).
    2. Fig 2: Removing/Installing Intake Manifold Bolts
    GM1403311Courtesy of GENERAL MOTORS CORP.
  2. Remove the manifold absolute pressure (MAP) sensor (714). Refer to Intake Manifold Removal (RPO LY2/LY6/L92) or Intake Manifold Removal (RPO LH6/LMG/LY5/LC9/L76) .
  3. Remove the evaporative emission (EVAP) canister purge solenoid valve, EVAP tubes, and fuel rail with injectors. Refer to Fuel Rail and Injectors Removal .
  4. Remove the throttle body and gasket. Refer to Throttle Body Removal .
  5. Clean the intake manifold (500) in solvent.
    6. CAUTION: Refer to Safety Glasses and Compressed Air Caution .
  6. Dry the intake manifold with compressed air.
scientia non olet · About LEMON Manuals