LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1125 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L (4 Of 5)) >> Off-Vehicle Repair Information (2 Of 3) >> Oil Pump Assemble

Oil Pump Assemble

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Oil Pump
    GM1402152Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Prior to assembling the oil pump, coat all wear or internal surfaces with clean engine oil.
  1. Install the driven gear (412) into the pump housing (413).

    Install the driven gear with the orientation mark facing the pump cover.

  2. Install the drive gear (410) into the pump housing.
  3. Install the oil pump cover (409).
    4. NOTE: Refer to Fastener Notice .
  4. Install the oil pump cover bolts (408).

    Tighten:  Tighten the oil pump cover bolts to 12 N.m (106 lb in).

  5. Install the relief valve (414).
  6. Install the relief valve spring (415).
  7. Install the relief valve plug (416).

    Tighten:  Tighten the relief valve plug to 12 N.m (106 lb in).

  8. Inspect the oil pump for smooth operation by rotating the drive gear.
scientia non olet · About LEMON Manuals