LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1125 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L (4 Of 5)) >> Off-Vehicle Repair Information (2 Of 3) >> Piston, Connecting Rod, and Bearing Cleaning and Inspection >> Measuring Piston Ring End Gap

Measuring Piston Ring End Gap

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Measuring Piston Ring End Gap
    GM4968Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Do not attempt to file the end of the piston ring to achieve the proper end gap clearance.
    • Measure the piston ring in the cylinder in which it will be used.
  1. Place the piston ring into the cylinder bore 6.5 mm (0.25 in) below the top of the ring travel area. Both rings should be installed with the orientation marks facing the top of the piston.
  2. Insert a feeler gage and measure the piston ring end gap. Refer to Engine Mechanical Specifications (RPO LY5 VIN J) or Engine Mechanical Specifications (RPO LC9 VIN 3) or Engine Mechanical Specifications (RPO LY2 VIN C) or Engine Mechanical Specifications (RPO LH6 VIN M) or Engine Mechanical Specifications (RPO LMG VIN 0) or Engine Mechanical Specifications (RPO LY6 VIN K) or Engine Mechanical Specifications (RPO L76 VIN Y) or Engine Mechanical Specifications (RPO L92 VIN 8) .
scientia non olet · About LEMON Manuals