Section 13 (Engine Mechanical - 4.6L (LH2) (4 Of 6))
WARNING: This page is about a different variant/trim than selected.
- Off-Vehicle Repair Instructions - Part 2
- Cylinder Head Removal - Left
- Camshaft Removal - Right Exhaust
- Camshaft Removal - Right Intake
- Valve Rocker Arm Removal - Right
- Valve Lifter Removal - Right
- Cylinder Head Removal - Right
- Oil Pan Removal
- Oil Pump Pipe and Screen Assembly Removal
- Lower Crankcase Removal
- Piston, Connecting Rod, and Bearing Removal
- Crankshaft and Bearings Removal
- Engine Block Disassemble - Upper
- Engine Block Cleaning and Inspection - Upper
- Engine Block Assemble - Upper
- Engine Block Cleaning and Inspection - Lower
- Crankshaft and Bearings Cleaning and Inspection
- Crankshaft Balancer Cleaning and Inspection
- Engine Flywheel Cleaning and Inspection
- Piston and Connecting Rod Disassemble
- Piston, Connecting Rod, and Bearings Cleaning and Inspection
- Piston Cleaning Procedure
- Piston Inspection Procedure
- Piston Diameter Measurement Procedure
- Piston Pin Bore Measurement Procedure
- Piston Ring End Gap Measurement Procedure
- Piston Ring Side Clearance Measurement Procedure
- Connecting Rod Cleaning Procedure
- Connecting Rod Visual Inspection Procedure
- Connecting Rod Measurement Procedure
- Piston and Connecting Rod Assemble
- Cylinder Head Disassemble
- Cylinder Head Cleaning and Inspection
- Valve Spring Inspection and Measurement
- Valve and Seat Grinding
- Valve Cleaning Procedure
- Valve Visual Inspection Procedure
- Valve Measurement and Reconditioning Overview
- Valve Seat Width Measurement Procedure
- Valve Seat Roundness Measurement Procedure
- Valve Margin Measurement Procedure
- Valve-to-Seat Concentricity Measurement Procedure
- Valve and Seat Reconditioning Procedure
- Valve Stem Height Measurement Procedure
- Cylinder Head Assemble
- Camshaft Cleaning and Inspection
- Valve Lifters Cleaning and Inspection
- Valve Rocker Arms Cleaning and Inspection
- Camshaft Intermediate Drive Shaft Cleaning and Inspection
- Camshaft Timing Drive Components Cleaning and Inspection
- Camshaft Position (CMP) Actuator Housing Disassemble
- Camshaft Position (CMP) Actuator Housing Cleaning and Inspection
- Camshaft Position (CMP) Actuator Housing Assemble
- Oil Pump Disassemble
- Oil Pump Cleaning and Inspection
- Oil Pump Assemble
- Oil Pump Outlet Tube Cleaning and Inspection
- Oil Filter Adapter Disassemble (Without Oil Cooler)
- Oil Filter Adapter Disassemble (With Oil Cooler)
- Oil Filter Adapter Cleaning and Inspection (Without Oil Cooler)
- Oil Filter Adapter Cleaning and Inspection (With Oil Cooler)
- Oil Filter Adapter Assemble (Without Oil Cooler)
- Oil Filter Adapter Assemble (With Oil Cooler)
- Oil Pan Disassemble
- Oil Pan Cleaning and Inspection
- Oil Pan Assemble
- Oil Pump Pipe and Screen Cleaning and Inspection
- Engine Front Cover Disassemble
- Engine Front Cover Cleaning and Inspection