Tools Required

WARNING: This page is about a different variant/trim than selected.

J 22738-B Valve Spring Tester

Fig 1: Inspecting Valve Spring

Courtesy of GENERAL MOTORS CORP.

Place the valve spring in the J 22738-B .
Compress the J 22738-B to the valve open, valve spring compressed, dimension listed in the Engine Mechanical Specifications .

NOTE: DO NOT use shims in order to increase valve spring load. The use of shims will cause the valve spring to bottom out before the camshaft lobe is at peak lift and engine damage could result.

If low valve spring load is found to be too low, replace the valve spring, DO NOT shim.