Installing the pressure line between the air conditioning compressor and the air conditioning condenser
- Replace O-rings.
Parts: O-rings
- Feed in and correctly position the pressure line (2) between the air conditioning compressor and the air conditioning condenser.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Refrigerant lines to air conditioning condenser/connecting piece | ||
| M6 | Tightening torque | 13 Nm |
NOTE:
TECHNICAL INFORMATION
Secure component against falling.
Secure component against falling.
- Position the refrigerant lines on the air conditioning compressor (2).
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Refrigerant line on air conditioning compressor | ||
| M8 | tightening torque | 19 Nm |
- Connect connectors (3) and lock.
- If necessary, insert the coolant hose (1) into the holder (2) and position it correctly.
- Connect the connector (1) to the alternator (2) and lock.
Follow-up work
- Refer to INSTALLING THE AIR CONDITIONING COMPRESSOR (PARTIALLY INSTALLED) .
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING THE COVER FOR CENTRAL ENGINE COMPARTMENT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING CONTROL UNIT BRACKET .
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to INSTALLING THE DME CONTROL UNIT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to ACTIVATING ELECTRICAL SYSTEM .
- Refer to EVACUATING AND CHARGING CONDITIONING .