Install the rear blower

• Feed the rear blower (2) into the center console (3) and install.
  NOTE: Fasten the adjacent threaded plate for the screws (1) in the center console (3) from the top.
• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Rear blower to center console
  screw	Tightening torque	1.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Correctly route the cable (2) and engage with the cable brackets (3).
• Connect the connector (1) for the rear blower and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect plug (1).
• Position the interior antenna (2) correctly and slide in the direction of the arrow until the detent (3) engages.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the air duct (1) on the guides (3) from the top.
• Correctly slide the air ducts (1) at bottom onto the rear blower (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Route the cable (1) correctly.
• Engage the cable bracket (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE FRONT STORAGE COMPARTMENT .
• Refer to INSTALLING THE CENTER CONSOLE .
• Refer to INSTALLING THE CUP HOLDER .
• Refer to INSTALLING THE CENTER ARMREST .
• Refer to INSTALLING THE CENTER CONSOLE TRIM .
• Refer to INSTALLING THE LEFT AND RIGHT KNEE PAD .
• Refer to INSTALLING THE CENTER ARMREST STORAGE COMPARTMENT .
• Refer to INSTALLING THE CARPET ON THE CENTER CONSOLE AT LEFT AND RIGHT SIDES .
• Refer to INSTALLING THE REAR CENTER CONSOLE TRIM .
• Refer to ACTIVATE VEHICLE-SPECIFIC HIGH-VOLTAGE OR LOW-VOLTAGE ELECTRICAL SYSTEM .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .