Install the rear top cross connection
- Feed in and position the rear top (3) cross connection.
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Rear cross connection at the top of the hood lock support | ||
| Hexagon screw M6x20 |
Tightening torque | 8 Nm |
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Rear top cross connection to wheel arch carrier support | ||
| M10x50 screw Replace screw. |
Snug torque | 56 Nm |
| Angle of rotation | 90° | |
Follow-up work
- Refer to INSTALLING MOUNT OF HOOD SEAL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE COVER PANEL OF THE ENGINE COMPARTMENT ON THE REAR LEFT AND RIGHT .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .